DongFeng DFA1063DJ10-301, Service Manual

Page: 36 / 142

Transmission
MT-12
3.Put the needle bearing and spacer into reverse speed
gear inner hole, put the reverse speed gear through the
reverse speed gear inspecting hole, insert the reverse
speed gear shaft from the transmission casing rear end,
seize the lock plate with the bolt to fix it.
4.Put the main shaft into casing, cover the rear bearing
from mainshaft rear end, tap the bearing with copper
rod to make the bearing get close the shoulder of main-
shaft spline, cover the drive gear of speedometer and
spacer, then put the snap ring at bearing outer ring.
5.Press the rear bearing into input shaft, assemble the
snap ring and the steel ring of bearing outer ring, put
the mainshaft front bearing into inner hole.
6.Put the input shaft into casing front end bearing hole,
align the mainshaft front end axle journal with the
front bearing hole, tap the input shaft rear bearing
slightly with copper rod, rotate the input shaft with
had, put the bearing into casing seating hole smoothly.