7
MAINTENANCE
■
Cleaning the water inlet filter.
• “IE” error message (refer to troubleshooting guide) will display when the water does not enter the detergent case.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
And the water leaks from the water inlet.
• It is therefore a good idea to clean it from time to time.
■
Cleaning the drain filter.
• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be caused.
CAUTION :
Be careful when draining if the water is hot.
1. Open the cover-pump(
1
)
by using coin.
Separate the cover-pump(
1
)
from the washing machine.
2. Install the cover-pump(
1
) to the
lower frame(
2
).
Open the pump-filter(
3
) slowly
and allow the remaining water to
flow into a suitable container.
3. Remove foreign objects
from the pump-filter(
3
) and
clean the interior.
Close the pump-filter(
3
) and
replace the cover-pump(
1
).
1
2
1
3
1
3
1
Turn off the water tap.
2
Separate the inlet hose.
3
Pull out the inlet filter.
Clean the inlet filter with
the brush.
4
Connect the inlet hose.
■
D-NT1021*P / NT1022*P / NT1023*P SERIES
1. Open the lower cover(
1
) by
using a coin. Remove the cap
hose(
2
) to pull out the hose.
2. Unplug the cap hose(
2
),
allowing the water to flow out.
At this time use a vessel to
prevent water flowing on to the
floor. When water does not flow
any more, turn the pump
filter(
3
) open to the left.
3. Remove any foreign material
from the pump filter(
3
). After
cleaning, turn the pump filter
clockwise and insert the cap
hose(
2
) to the original place.
Close the lower cover.
■
D-NT1021*F / NT1022*F SERIES
1
100
2
3
2
3
