7
Donaldson Company, Inc.
hopper
leg
cross brace
Leg and Cross Brace Assembly (Knock-Down Version Shown)
Standard Equipment
After removing any accessory equipment that may have
been stored inside collector, all welded collectors can be
lifted from the truck to the prepared site. Bolt-together
collectors are assembled at the site.
2. Place the hopper upside down on a flat secure
surface.
3. Attach legs to hopper gussets using the hardware
supplied. Assemble cross braces as shown in Leg
and Cross Brace Assembly. Do not tighten hardware
at this time.
4. Turn leg and hopper assembly over and position over
anchor bolts. Secure each leg pad to the foundation
anchor bolts with customer-supplied flat washers,
lock washers, and nuts. Do not tighten hardware at
this time.
5. Level hopper.
6. Tighten all hardware securing legs, cross braces,
hopper gussets, and foundation anchor bolts.
Reference Typical Foundation Anchor and leg assembly
drawing shipped with the collector prior to starting
assembly.
1. Prepare the foundation or support framing in the
selected location. Locate and install anchors.
Tighten all hardware before
removing crane to prevent
personal injury and/or property damage.
Note: If installing an all-welded collector, skip to
Inlet Scroll Installation.
Anchors must comply with local
code requirements and must be
capable of supporting dead, live, wind, seismic,
and other applicable loads.
Anchor sizes shown are provisional, as final
anchor sizing will depend on jobsite load
conditions, collector location, foundation/
framing design variables and local codes.
Consult a qualified engineer for final selection
of suitable anchors.
Temporary support is required
until all legs and cross-bracing
are in place.
Leg Installation
