21
EN
11
INSTALLATION INSTRUCTIONS
Unscrew the four bolts and remove the outer cover from the
rear of the boiler.
Remove the two nuts and take out the inner cover
and the seal.
Open the boilers doors. Remove the manual ash drawer.
Slot the inner compressor drawer
(18)
into the
boiler, place the closing support
(19)
and fix it in
place tightening the screws
(20)
.
Unscrew the bolts that attach the door and pull the lower
door down to remove it.
Fit the motor support
(10)
to the rear of the boiler
together with the insulating gasket
(11)
, ensuring
the shaft is centred as correctly as possible in the
hole in the gasket.
Summary of Contents for BioClass HM 10
Page 34: ...32 NOTES ...
Page 35: ...33 NOTES ...
