29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
[email protected] | www.domuslighting.com
Installation Manual
Note
:
• Please switch the power off and let the lamp cool before touching the lamp(s).
• When adjusting lamp holders, ensure that lamps are not touching or in close proximity to sensor head
(more than 40mm), heat from the lamp(s) may distort the PIR Sensor or destroy the plastic encloser of PIR
Sensor.
• Loosen lock nuts and screws on sensor and lamp before making any adjustments.
• Do
NOT
attempt to open the fascia of the spotlight, as this will void warranty.
Notes for electrician
The security lamp should be wired to its own light switch.
Do not interconnect with other lights on the same switch.
Earth connection must be required.
Understanding the controls
Adjusting the duration time: The length of time that remains
switched on after activation can be adjusted from (10±5) seconds
to (4±1) minutes. Rotating the TIME knob + to - will reduce the
duration time.
Note: Once the light has been triggered by the PIR sensor any
subsequent detection will start the timed period again from the
beginning.
Adjusting the LUX control level: The Lux control module has a
built in sensing device (photocell) that detects daylight and
darkness. The ( ) position denotes that the floodlight can work at
day and night, and the ( ) position only work at night. You can set to
operate the unit at the desired level by adjusting the LUX knob.
Adjusting the sensitivity: The sensitivity means the Maximum
distance which PIR Sensor can be triggered by movement body.
Turning the SENS knob + to - will decrease the sensitivity.
Setting the controls
1.
Put the Lux control knob to light ( ) position, turn the wall switch on and wait half a minute for the control
circuit to stabilise. At this stage ensure that the TIME control knob is set at minimum duration. The security
lamp will now switch on and remain on for about 30 seconds (within 60 seconds).
2. Direct the sensor toward the desired area to be scanned by adjusting the elbow joint and swivel joint on
the
sensor
arm.
Important: loosen all lock nuts and screws on sensor and lamp before making any adjustments.
3.
Have another person move across the centre of the area to be scanned and slowly adjust the angle of the
sensor arm until the unit sensors the presence of the moving person, causing the light to switch on.
4.
Adjust time control to required setting.
5. To set the light level at which the lights will automatically switch “on” at night, turn the LUX control knob
from daylight to night. If the lamps are required to switch on earlier, e. g. Dusk, wait for the desired light
level, then slowly turn the LUX control knob towards daylight while someone walks across the centre of the
area to be detected. When the floodlights switch on, release the LUX control knob. You may need to make
further adjustments to achieve your ideal light level setting.
Control Knob
SENS
TIME
LUX
