LAB1283R, Issue 2, Apr 2017
Page 24
Press the “
+
” and “
-
“ buttons to move along the timeline at the bottom of the screen; a
block will be
added
to each position.
To remove a block, remove the word “
BYPASS
” from the screen by pressing “
BYPASS
”
and press the “
+
” and “
-
“ buttons to move along the timeline at the bottom of the screen; a
block will be
removed
from each position.
Daily ‘timeline patterns’ can be
copied
to another day or multiple days to avoid
programming each day individually.
From the home screen, press “
COPY
”
Select the day to copy by pressing “
PROG
” (the day number will be displayed) and then
the day to copy-to by pressing the “
+
” and “
-
“ buttons (the day number will flash). When
the two correct days have been selected, press “
COPY
” and the timeline pattern will copy
across.
Press
“SET”
to record
5.14 Filter reminder
The word ‘Filter’ will appear on the home screen after the set time has elapsed. When this
occurs, clean the filters (see section 6)
Note: The figure at the bottom of the screen indicates elapsed operating time in hours.
When the numbers are
not
flashing, they indicate the elapsed time since the last filter
reset. If “
DAY
” is pressed, the numbers will flash and indicate the total elapsed operating
time in hours.
To reset the filter elapsed time reminder following cleaning, press and hold “
SET”
for 5
seconds.
LAB1283R, Issue 2, Apr 2017
Page 9
2.0 Installation
2.1 Overview
2.1.1 The following instructions are intended to help prevent hazards. Installation should only be
carried out by a qualified electrician and competent persons in clean, dry conditions where
dust and humidity are at minimum levels
Note: we advise installers to fix all mains, switch and sensor wiring (in accordance with the
latest edition of the Wiring Regulations) prior to fixing the HRX2D unit in position
2.2 Preparation
2.2.1 When accepting delivery of the appliance, inspect for transit damage. If in doubt, call our
Customer Services team on 03443 715523
2.2.2 The HRX2D unit must be fitted horizontally in a portrait orientation to a vertical and solid
flat surface using the fixing bracket provided
2.2.3 Appropriate screw fixings to suit the support medium will need to be supplied by the
installer. The built-in mounts suit 4 x 4mm (No.8) pan head screws
2.2.4
Important:
Ensure that there is sufficient space for access to the wiring centre (cover
removal), the condensation fittings and ductwork
2.2.5 Ensure that there is sufficient space below the appliance to access the filters and for
carrying out any future maintenance on the appliance
2.2.6 To wall mount the unit, firstly decide on the correct handing (left or right) based on the
most convenient duct routing to inside and outside the property. Once established, lift up
the 2 folded away mounting brackets which will be at the back of the unit into an upright
position. Drill 2 holes at 460mm centres and level with each other onto the surface to
which the unit will be mounted. Using suitable fixings, securely attach the unit to the wall.
460mm
V E N T I L A T I O N
V E N T I L A T I O N
