ENGLISH
MERELY ILLUSTRATIVE IMAGES.
Products may suffer changes in its components without prior warning. If any questions,
contact Dompel.
Install your Dompel product in a level place with no grooves or splices, preventing rocking
and vibration. The location must be airy and it must not allow straight sunlight and it must be
product outdoors.
Avoid accidents. After unpacking the product, keep all the pack material out of children’s
reach.
Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene,
gasoline, bleach, thinner, solvents, varsol, vinegar or other chemicals or abrasives not
recommended in this manual.
To easily clean it, use a solution of warm water with a neutral soap and then wipe dry
carefully. The plastic parts can not be washed with boiling water. Perform periodic cleaning,
LOCATION OF INSTALLATION
CLEANING AND MAINTENANCE
SECURITY
INSTALLATION AND ASSEMBLY
Remove all components from the package. The 4 casters are in a plastic bag inside the
carton. The assembly of this product is totally manual and requires no tools.
1
Manually assemble the 04
casters (B) to the bottom of the
assembled structure (A) (make
sure they are snug and aligned
when supported on the floor).
4
6
Manually attach the Table set
(C) to the assembled structure
(A). Use the handle (D) to
manually fasten the desired
position (height and turn of the
table).
5
Remove the acetone pump
dispenser (G) and the
anatomical manicure bowl (H)
from inside of one of the
drawers of the assembled
structure (A) and manually
attach to the spaces on both
sides of the table as required.
NOTE: The table in this
manicure stool contains a
translucent plastic top with a
side sliding opening that gives
access to a built-in space to
accommodate cotton. The seat
structure allows access to 3
drawers on the right side and on
the left side there is a side
access door with key locking
(included in the product).
2
Manually attach the footrest set
(F) to the fixed support set (E).
Tighten the lower handle (D) to
fasten the height to the desired
position and the upper handle
(D) to fasten the angle position
of the footrest.
3
Manually assemble the fixed
support set (E) into the center
fitting of the assembled
structure (A), located just
below the upholstered seat.
