DO9043W
Crispy Mode (CRISP)
If you want to bake your wafers so that they are more crunchy and crispy, press on
the [CRISP] button after the preheating phase and the button’s indicator light will
automatically switch on.
If you use the pre-set baking time of 2 minutes or have set the desired time length
manually, press on (START). After 10 seconds the baking tray will start to rotate and
baking will begin. Meanwhile the time you set will run back to 0:00. After baking time
has finished you will hear an acoustic signal 4-times and see the previous baking time
settings on the display. The (Ready) light will switch on.
The Stop Button (STOP)
During the baking time you can interrupt the process by pressing on STOP. After
this you can adjust the baking time by pressing on the timer button (TIME), setting a
different time and then pressing on START to continue the baking process.
Standby
If none of the buttons are used during ± 45 minutes, the appliance will go into stand-
by. The temperature of the baking trays will fall; the display will show the last time
setting used. Pressing on any button will be enough to activate the preheating phase.
You will hear the acoustic signal 1-time.
ERROR MESSAGES
If you see “FINISHED” on the display: There is a break in the wiring.
If you see “SC” on the display: There is a short circuit.
In both cases switch the appliance off and remove the plug from the socket. Allow
onkly the manufacturer, its after sales service point personnel or an equally qualified
person to inspect the appliance in order to prevent accidents.
The baking trays do not rotate
If you fill the wafer iron after preheating and it expands too quickly or if you use self-
raising flour or yeast, the baking tray may turn slightly upwards. After 10 seconds
baking time the appliance will try to rotate the baking tray. As a result of the top
baking tray not closing properly, the axle will not be able to turn.
Pressing the baking tray down lightly by holding the insulated handles to close the
baking trays so that the appliance can rotate the baking trays is sufficient. Touch only
the insulated handles and not the baking trays, they can become very hot.
Acoustic Signal
If you have not done this within 1 minute, the appliance switches the motor off
automatically and you will hear the acoustic signal 4-times. Press the top baking tray
as described above by holding the insulated handles and pressing downwards until the
baking trays are closed and then press on START to begin the baking process again.
21
Summary of Contents for DO9043W
Page 25: ...DO9043W 25...
