7
X-TEND A-ROOM
TM
INSTALLATION AND OPERATING INSTRUCTIONS
E. Operating Tips
1.
Privacy panels can be unzipped and rolled up to
allow air circulation.
2.
The front panel can be unzipped and rolled up;
however, this will open the end of the room and the
possible danger of someone stepping off the ramp.
3.
Storage pockets are located on both sides of the X-
Tend A-Room
TM
for personal items.
Important:
If trailer is equipped with a bed, DO NOT
ROLL BED DOWN if room poles are in place.
F. Room Storage
Note: If room is put away when conditions are wet, it should
be set up and allowed to dry as soon as possible to prevent
FIG. 11
Place Grommet On Ramp, Mark
Location For Twist Fastener
Installation
View From
Inside Room
Twist Fastener
5.
Loosen the lock levers and lower the rear/frame pole
assembly to its shortest height. Place levers in the
lock position. The entire X-Tend A-Room
TM
will be
completely on the ramp. Loosen the locks on the
horizontal pole and collapse to the shortest length.
Remove vertical side pole from the horizontal pole
and slide it out of the sleeves on the fabric. Repeat
for other side. Do the same with the horizontal pole
and take apart the entire rear/frame pole to be placed
into the pole storage bag. Tie the pole storage bag
closed.
6.
The room is folded by bringing the sides into the
middle. Fold the each side again to the middle until
the fabric is the width of the pole storage bag.
7.
Roll the fabric assembly tightly around the poles in
the pole storage bag squeezing out the air. Insert the
fabric and poles into the X-Tend A-Room
TM
storage
bag. Store in a dry place.
8.
Disassemble ramp stands in reverse of assembly
(see section "A" on page 3), and place in the storage
bag.
WARNING
!
Personal injury may result from falling or step-
ping off the end of the cargo ramp when the
fabric is open and rolled up.
mold and mildew.
1.
Loosen and unfasten buckle straps at rear top
corners of the X-Tend A-Room
TM
.
2.
Unfasten hooks on the elastic cord and twist fasten-
ers at bottom of room front corners.
3.
Remove center roof pole assembly by unclipping
the C-clip from arched front pole assembly. Remove
the Center pole support with ball socket from rear/
frame pole assembly. Disassemble center pole and
place in pole storage bag.
4.
Carefully pull the ball ends out of the sockets.
Loosen the lock levers and shorten the side poles to
the shortest length and lock the levers. The front
fabric will start to collapse. Remove the five hook/
loop straps from the arch and the pole assembly is
free and the fabric will fall to the ramp. Disassemble
front pole and place in pole storage bag.
