EN
CF18 – CF60
Operation
19
I
✓
The cooler starts cooling the interior.
I
Latching the cooler lid (CF35, CF40)
➤
Close the lid.
➤
Press the latch (fig.
2
1, page 9) down, until it latches in place audibly.
7.6
Setting the temperature
A
CF18
➤
Set the cooling level with the temperature controller (fig.
3
1, page 9).
CF25, CF35, CF40, CF50, CF60
➤
Press the “SET” button (fig.
4
4, page 10) once.
➤
Use the “UP +” (fig.
4
6, page 10) and “DOWN –” (fig.
4
7, page 10) buttons
to select the cooling temperature.
✓
The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
7.7
Using the Emergency Switch
The emergency override switch (fig.
5
2, page 11 and fig.
6
4, page 11) is located
in the connection panel.
➤
For normal operation the switch should be in the NORMAL USE position.
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
NOTE
During low voltage:
If switched off by the battery monitor due to low voltage, the display
goes blank, and the LED “POWER” flashes orange.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
CF18-CF60-O-AUS.book Seite 19 Dienstag, 17. September 2019 8:49 08
