Dometic VacPort, Installation And Operating Manual

Page: 8 / 116

EN
Installing the VacPort VacPort
8
5 Installing the VacPort
!
A
I
➤
Place the trim plate (fig.
1
2, page 2) at floor level against the wall and mark the
section inside the trim plate.
➤
Saw out the section (fig.
1
, page 2).
➤
Glue the mounting connector (fig.
2
5, page 2) onto the device-side on the
VacPort connection (fig.
2
1, page 2).
➤
Insert the 90° elbow piece (fig.
2
1, page 2) onto the mounting connector
(fig.
2
5, page 2).
➤
Separate the suction hose (fig.
2
2, page 2) between the central vacuum
cleaner and hose socket.
➤
Turn the screw connector (fig.
2
3, page 2) in all hose ends.
➤
Connect the hose ends to the Y-piece (fig.
2
4, page 2) and to the elbow piece
(fig.
2
1, page 2).
➤
Connect the orange-coloured 24 V
g
cables on the back of the central vacuum
cleaner with the contacts on the sweep inlet valve (fig.
4
, page 3) according to
the circuit diagram (fig.
3
, page 3).
➤
Fit the sweep inlet valve (fig.
1
2, page 2) in the wall.
WARNING! Danger of electrocution and serious injury.
Beware of electrical cables in the wall when drilling and sawing.
NOTICE!
•
Install the VacPort in a dry place.
•
Do not install the VacPort in an area which is subject to high
temperatures.
•
Do not bend the connection cable round sharp edges or corners.
Keep the connection cable away from heated surfaces.
NOTE
The mounting connectors need to be glued on the device-side using a
standard adhesive. The screw connectors are screwed into the
connection hose and inserted into the mounting connectors.
VacPort-IO-16s.book Seite 8 Donnerstag, 28. Juli 2016 11:42 11