2.
Secure the refrigerator and the lower front strip with
two screws: One screw through each hinge.
See FIG 6.
Step 2: Two screws installed in the top frame.
The top decoration panel must be removed from the
refrigerator before the screws can be installed.
Open the doors and remove the screws holding the top
decoration panel (both sides). The screws are acces-
sible from underneath. See FIG. 7.
Carefully tilt the top decoration panel and lift up to
remove from top frame. Be careful not to damage the
circuit board and wires.
Install the two screws in the top frame, the holes are
accessible from underneath.
Seal the opening for the screws with aluminum tape.
Replace the top decoration panel with its two screws.
Be careful not to pinch the wires behind the panel.
Step 3: Two screws installed in the rear base.
See FIG. 8.
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and
cabinet. Any space between the counter, storage area
or ceiling and top of the refrigerator greater den 1-1/2
inches should be blocked. The heat produced at the rear
of the refrigerator will become trapped in this space,
making the top of the refrigerator hot and reduce the
efficiency of the refrigerator.
Drain water hose
The drain water hose has to be routed either to the lower
side vent or through the floor. The installer MUST make
sure that the hose does not kink when run through the
floor. Seal around the hose that goes through the drilled
hole. If a longer hose than supplied is required to get the
water to drain outside of the vehicle, the installer will
have to supply the extra length of hose.
TESTING LP GAS SAFETY
SHUTOFF
The gas safety shutoff must be tested after the re-
frigerator is connected to LP gas supply.
To test the gas safety shutoff, proceed as follows:
1.
Start the refrigerator according to the instructions,
and switch to GAS mode. (See start up instructions).
2.
Check that the gas flame is lit and the GAS mode
indicator lamp (C) is on.
3.
Close the manual gas shutoff valve at the back of the
refrigerator. (See FIG. 1).
4.
Wait for one minute. The CHECK indicator lamp (D)
should be on and the GAS mode indicator lamp (C)
should be off.
5.
Remove protection cover (see FIG. 1) and open the
manual gas shutoff valve. Do not change any button
positions on the control panel. Apply a non-corrosive
commercial bubble solution to the burner jet orifice.
6.
No bubbles should appear at the opening of the
burner jet orifice. The presence of bubbles indicates
a defective gas safety shutoff, and service is re-
quired.
7.
If no bubbles were present at the burner jet orifice, it
should be rinsed with fresh water. Be careful not to
damage the burner jet orifice. Replace cover and
press the main power ON/OFF button (1) OFF and
back ON. Normal operation of the burner should
return. Allow the burner to operate for a minimum of
five minutes.
FIG. 6
FIG. 7
FIG. 8
Hole for drain water hose
Screws
6
Summary of Contents for RM 7832
Page 2: ......
Page 16: ...MO FO 9848 ...
