Dometic PerfectCharge SMP 439A, Installation And Operating Manual, Page: 13 / 284

EN
SMP439A Installing the device
13
5.1 Connections and controls
6 Installing the device
6.1 Fastening the device
When selecting the installation location, observe the following instructions:
•
The device should be installed vertically.
•
Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
•
The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The clearance around the
device must be at least 25 cm.
•
The air inlet on both short sides of the device must remain clear.
•
For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the device under load can lead to
reduced output.
•
The device must be installed on a level and sufficiently sturdy surface.
•
Do not install the device in the same area as the batteries.
•
Do not install the device above batteries, because they can emit corrosive sul-
phur fumes that will damage the device.
A
No. in
fig.
1
, page 3
Explanation/function
1 Input for AC power supply
2 Status LED
3 Battery type selector button
4 Battery connector
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
SMP439A-IO-16s.book Seite 13 Freitag, 23. November 2018 11:09 11