EN
Installation
MCS T6, MCS T12, MCS T16
20
8.3
Blower Assembly
Rotate the blower to allow the most direct flow of air to the supply-air grille
(fig.
5
, page 4).
➤
Loosen the adjustment screw (
1
).
➤
Rotate the blower (
2
).
➤
Tighten the adjustment screw (
1
).
8.4
Electrical Box
Mind the following notes on the installation of the electrical box (fig.
8
3,
page 6):
•
Mount the electrical box in a dry location.
•
Mount the electrical box to a flat, solid surface within 1 m of the unit.
•
Mount the electrical box within 4.5 m of the location where the digital con-
trol will be installed.
➤
Use the 4 mounting slots in the back of the electric box to attach it to a suita-
ble mounting surface.
➤
Use screws appropriate for mounting surface (not included).
8.5
Supply-Air Grille
Mind the following notes on the installation of the supply-air grille to ensure
direct uninterrupted airflow from the blower:
A
•
Install the supply-air grille as high as possible.
•
A minimum clearance of 76 mm plus the duct diameter size is required
behind the supply-air grille for attaching the ducting.
➤
Create the cut outs for the supply-air grille according to the following table:
➤
Mount the supply-air grille.
NOTICE!
In no instance should the supply-air grille discharge be directed towards the
return-air grille, as this will cause the system to short cycle.
MCS T6
MCS T12
MCS T16
4.9" x 4.9"
125 x 125 mm
9.9" x 5.9"
252 x 150 mm
9.9" x 7.9"
252 x 201 mm
MCS-T6-T12-T16--I-16s.book Seite 20 Dienstag, 14. November 2017 11:09 11
Summary of Contents for MCS T12
