Dometic MagicSafe RRC90, Installation And Operating Manual

Page: 8 / 118

Connecting electrical power to the wireless receiver RRC 90
EN
6
7.1 Installing the wireless motion sensor (accessory)
See fig. 6 and fig. 7
When installing the motion sensor, observe the following instructions:
•
Choose an installation location that allows the entire vehicle interior to be monitored (fig.
6
).
•
The motion sensor can detect movements at a distance of maximum 12 m. It cannot detect
movements behind stationary objects such as partitions. If appropriate, use several motion
sensors.
•
Try to avoid blind spots by positioning the sensors well.
•
Do not install the motion sensor at a height of more than 2 m above the vehicle floor.
•
Do not install the motion sensor close to sources of heat, such as heaters, or outlet nozzles for
warm air.
➤
Press the housing of the motion sensor in slightly on both sides and remove it from the rear
panel (fig.
7
).
➤
Screw the rear panel to a suitable installation location.
➤
Put the housing back onto the rear panel and click it into place.
8 Connecting electrical power to the wireless receiver
8.1 Connection cables of the 18-pole plug
See fig. 8 and fig. 9
White/black (P3)
Connect this cable with the black cable of the status LED during the programming procedure.
Connect the red cable from the status LED to +12 V (terminal 30) during the programming
procedure.
Black (P5)
Connect this cable to the earth (terminal 31) or
connect this cable to the earth-controlled cable of the alarm system (e.g. DVS 90 alarm system).
Light blue (P7)
Connect the light blue cable to the earth (terminal 31) during the programming procedure, to start
the programming mode.
Red (P9)
Connect this cable to a cable with a per12 V charge (terminal 30).
RRC90-IO-16s.book Seite 6 Donnerstag, 18. August 2016 9:58 09