[page 10] | gpelectric.com
INSTALLATION
4.3 MOUNTING THE REMOTE DISPLAY
T
he remote display can be mounted by following these steps.
1. Plan the location of your remote display carefully. Keeping in mind the cable needs to be run
from the shunt to the monitor.
2. Use the installation template on the last page of this manual to cut a hole.
•
The remote display uses clips to stay in place so the hole size needs to be as accurate
as possible.
• Using a jigsaw is recommended.
3. Run the shielded cable from your battery bay and feed it through the cut hole.
4. Conne
ct the shielded cable to the remote and snap the remote into place.
4.4 MOUNTING THE SHUNT
The shunt comes with a mounting bracket that should be secured using screws to ensure the shunt
does not move
.
NOTE
4.2
WIRE CONNECTIONS
1. Before doing anything, disconnect all wires from the negative side of the battery.
2. Cut the negative cable for the battery and crimp on new ring terminals. Alternatively, use a
new wire of appropriate gauge to carry the full current demand of the system.
3. Connect the shunt as shown in the wiring diagram above.
The negative terminal of the battery must connect directly to the “B-“ side of the
shunt and there should be no other connections to the negative terminal of the
battery.
4. Using the red wire, connect the ring terminal end of the wire to positive of battery. The other end
connects to B+ of Shunt.
Do not stack smaller terminals under large ones.
5. Connect the Shunt to the GP-BMK-25 using the shielded wire to test. If done correctly the display will
turn on. Disconnect again so remote display can be mounted.
NOTE
Summary of Contents for GP-BMK-25
Page 2: ......
