Dometic FlyTec FT100, Installation And Operating Manual

Page: 14 / 160

EN
Installing the flyscreen FlyTec FT100
14
➤
Fit the guide cables into the bottom and top deflection screw (fig.
6
2 and 3.
page 5).
➤
Have two people carefully lift the pre-assembled flyscreen and position it in the
vehicle.
Adjusting the top guide rail
➤
Check whether the contour and position of the upper guide rail fit the vehicle
(see enlarged inset in fig.
8
, page 6). You may need to adjust the upper guide
rail by cutting the two upper legs.
5.4 Securing the flyscreen in the vehicle
A
Securing the skirting board and upper guide rail
➤
Align the position of the cassette profile perpendicular to the skirting board and
the upper guide rail.
➤
Secure the skirting board to the bottom plate (fig.
7
, page 6) with four counter-
sunk screws (Ø 4 mm).
➤
Secure the upper guide rail to the vehicle (fig.
8
, page 6) with four countersunk
screws (Ø 4 mm).
Installing the cover on the B pillar (fig.
9
, page 6)
A
➤
Put the cover on the B pillar so that it is flush on all sides.
➤
Align the cover on the bottom of the skirting board and mark the drill holes.
➤
Pre-drill at the marked points if the wall construction requires this.
➤
Secure the cover on the B pillar with five countersunk screws (Ø 4 mm).
NOTICE!
•
Choose suitable screws depending on the floor and roof
construction.
•
Make sure that you do not drill through the floor and roof.
NOTICE!
•
Depending on the type of vehicle, the spacers behind the cover
must be adapted to the correct length.
•
The contour of the cover may need to be adapted to the interior
fittings in the upper and lower area.
•
It may also be necessary to adapt the interior fittings.
FT100-IO-16s.book Seite 14 Montag, 3. April 2017 6:37 18