Dometic CRE0050, Installation And Operating Manual

Page: 22 / 348

EN
Installing and connecting the refrigerator CRE
22
• Condensate is produced when the refrigerator is operating normally. You can
either wipe up the condensate on the floor of the refrigerator in regular intervals,
or drain it through an outlet in the floor of the refrigerator (see chapter “Mounting
the outlet port (optional)” on page 22).
7.3 Mounting the outlet port (optional)
➤
Connect a hose with an inside diameter of 10 mm (not included) to the outlet
port.
➤
Lay the refrigerator on its side in order to access the bottom side.
A
➤
Mount the outlet port (fig.
6
2, page 5) aligned to the front or to the back
according to the desired outlet direction.
➤
Remove the drain plug (fig.
6
1, page 5) inside the refrigerator.
7.4 Installing the refrigerator
Proceed as follows to install the refrigerator:
➤
If you wish to drain the condensate through a hose:
Mount the outlet port (see chapter “Mounting the outlet port (optional)” on
page 22)
➤
Undo the transport lock (chapter “Releasing the lock” on page 28).
➤
Open the refrigerator door.
➤
Remove the blanking plugs (fig.
7
2, page 6).
➤
Push the refrigerator into the recess.
➤
Fix the refrigerator in place using suitable screws (fig.
7
1, page 6).
➤
Press the blanking plugs (fig.
7
2, page 6) into the openings.
7.5 Changing the door hinge
You can change the hinge of the door, so that it opens to the left rather than the right.
➤
Proceed as shown in fig.
8
, page 7 to fig.
9
, page 7, to change the hinges.
NOTICE!
Do not switch on the device until it stood in an upright position for a
period of 4 hours.
CRE50-65-80_IOM_EMEA16.book Seite 22 Mittwoch, 30. September 2020 10:50 10