Dometic Coolmatic CSMP2, Installation And Operating Manual

Page: 11 / 48

EN
CSMP2 Installation and connection
11
5.2 Operating and display elements
6 Installation and connection
The cooler is installed in the drawer under the bed.
➤
Lift the mattress.
➤
Unscrew the four screws (fig.
1
, page 3) and take off the board.
➤
Pull out the drawer and take out the container (fig.
2
, page 3).
After you fit the cooler, you can put the container back in.
I
➤
Remove the screws (fig.
3
1, page 3) and unplug the panel beside the drawer
(fig.
3
2, page 3).
➤
Have the supply cable from slot X 7 (fig.
4
, page 3) to the cooler laid by a
specialist Mercedes Benz garage.
➤
Cut out a section for ventilation at the appropriate position on the panel (fig.
5
,
page 3).
➤
Push on the plate nuts supplied (fig.
6
, page 3 and fig.
7
, page 4).
➤
Feed the connection cable for the cooler through the hole provided (fig.
8
,
page 4).
➤
Fasten the cooler with the screws provided at the appropriate positions (fig.
9
,
page 4).
➤
Fasten the cooler cable to the position marked on the drawer using the clip
provided and place the rubber in the appropriate position (fig.
0
, page 4).
➤
Have the cooler cable connected to the cable laid by the Mercedes-Benz garage
from the fuse box behind the cover panel (fig.
a
, page 4).
➤
Push the drawer back in (fig.
b
, page 4).
No. in
fig.
c
,
page 5
Description Explanation
1 Temperature controller – Switches the cooler on or off
– Adjusts the temperature
NOTE
If you cannot fully pull out the drawer, this is how to release it:
CS-MP2-IO-West.book Seite 11 Dienstag, 14. März 2017 6:59 18