15
EN
Universal Air Conditioning Unit
Operation
Check Parameters
L1 to L2/N Volts
V
Have the indoor unit fan settings been checked? (Y/N)
Has the outdoor unit fan operation been checked? (Y/N)
Entering indoor unit air temperature
°F or °C
Leaving indoor unit air temperature
°F or °C
Outside air temperature
°F or °C
Total unit amperage in Cool Mode
A
7 Operation
This section contains the necessary information in
order to properly operate the air conditioner and the
Q3 control once the initial startup sequence has been
completed.
WARNING: FIRE AND/OR EXPLOSION
HAZARD .
R-410A refrigerant systems operate at higher
pressures than standard R-22 systems. Do
not
use
R-22 to service the equipment or components on
R-410A refrigerant equipment. Failure to obey this
warning could result in death or serious injury.
WARNING: BREATHING HAZARD . Failure to
obey these warnings could result in death or
serious injury .
• Refrigerants are heavier than air. They can “push out”
the oxygen in your lungs in an enclosed space. To
avoid possible death or difficulty breathing:
–
Never
sniff a refrigerant.
–
Never
purge refrigerant into an enclosed room or
space. All refrigerants must, by law, be reclaimed.
– If an indoor leak is suspected, thoroughly ventilate
the area before beginning work.
• Never
burn refrigerant as poisonous gas will be
produced.
• Always follow EPA guidelines.
WARNING: BURN HAZARD .
Liquid refrigerant can be very cold. To avoid
possible frostbite or blindness, avoid contact
and wear gloves and goggles. If liquid refrigerant
does contact your skin or eyes, get medical help
immediately. Failure to obey this warning could
result in death or serious injury.
I
This unit is factory charged with the required
amount of refrigerant. If refrigerant recharging is
required, call Dometic for the proper amount of
refrigerant required for this system.
I
The electrical power source must agree with the
units’ data plate rating. Check the tightness of all of
the electrical connections. Ensure all barriers and
covers are in place at this point.
7 .1 Understanding Button
Functions
I
For the button locations and Q3 control functions,
refer to “Q3 Control” on page 6.
The following list contains the button functions for the
Q3 control.
• Mode button –
Press and release to toggle between
the Off and all other modes of operation.
• Up button –
Press and release to display the set
point. Press and hold the Up button to increase the
set point. The set point increases one degree each
time the button is pressed.
