11
Set temperature a few degrees below room temperature. Note: The digital readout =
actual room temp. Press down or up arrow the readout will blink out the set point and
then return to room temp.
The fan will start immediately and the compressor will start after a 3 minute delay.
Check unit runs OK and cools.
OPERATING INSTRUCTIONS
Turn the unit on by pressing the
ON /OFF
button once
Press the
MODE
button to cycle through options
Cool, Dry, Heat , and Fan.
To select cooling, cycle mode button to highlight
COOL.
You may select either
High, Med, Low,
or
Auto
fan speeds by pressing the
FAN
button. It is recommended that you choose
Auto.
Now select the desired room temperature (herein refereed to as SETPOINT).
By pressing the
TEMP
up or down keys, the readout will flash the setpoint
temperature. Keep pressing the button until it flashes your desired setpoint.
In approx 5 seconds the display will resume reading the actual roomtemp.
The compressor will have a delayed start usually 3 minutes, before unit starts to cool.
NB: Any interruption to the power supply will cause the unit to delay compressor start
up.
For simply recirculating air, choose the
FAN
mode.
Choose any of the three fan speeds by pressing
FAN
button.
NB: Temperature button is invalid in Fan only mode.
To heat, press
MODE
button to highlight
HEAT.
Select desired setpoint temperature by pressing
TEMP
buttons up or down.
It is recommended that
AUTO
fan speed be selected.
More information https://www.caravansplus.com.au