5
FIG. 5
Door Edge
Guard
Inner Screen
Door
B. Prepare Awning Rail
Make sure awning rail is parallel to
RV floor, and is
NOT
warped or curved before in
-
stalling awning fabric. If awning rail is
NOT
straight,
awning fabric may wrinkle or stretch.
Select desired awning rail end (on RV) into which
awning fabric will be inserted. Flare (widen) that
end of rail with a flat-bladed screwdriver, and re
-
move (file) sharp edges. See (FIG. 6).
FIG. 6
Before
After
PREPARE FOR INSTALLATION
A. Door Roller And Edge Guard (Optional)
Do
NOT
allow corner of entry door
to contact awning fabric. Otherwise, premature
wear or tearing of awning fabric could occur.
If there is potential for a squared corner entry door
to contact awning fabric, a door roller kit (NOT IN
-
CLUDED) must be installed.
Rounded corner doors may
NOT
require a
door roller kit if there is no potential for dam
-
age to awning fabric.
See subsection, “B. Additional Components
& Kits” on page (5) to order door roller
kits.
1.
Install door roller. See (FIG. 4).
a.
Place door roller at upper corner (opposite
to hinge) of outer entry door. Face roller out,
and 1/4” to 3/8” above door.
b.
Place and tighten self-drilling screws (pro
-
vided) through mounting holes and into door.
FIG. 4
Position Wheel
Directly Over
Edge Of Door
Outer Entry
Door
1/4″ - 3/8″
(Above Door)
2. Clip door edge guard onto upper corner (oppo
-
site to hinge) of inner screen door. See (FIG. 5).
GENERAL INFORMATION
A. Included Hardware
(2) #10-16 X 5/8” Self-Drilling Screws
(*) #6-20 X 1/2” Square Drive Screw
* Quantity varies by length of awning rail.
B. Additional Components & Kits
(1) 830304
Door Roller Kit
(1) 830304.003 Door Roller Kits (50 Pack)
3310287.010
Electronic Control Kit
Although this kit includes a wiring harness kit, ad
-
ditional wiring (installer supplied) is still required.
3310287.002
Electronic Control Kit
This kit will require additional components and wir
-
ing (installer supplied):
(4) 350766-1
Plug (3 Position)
(4) 350777-1
Plug (2 Position)
(1) 350779-1
Plug (4 Position)
(6) 350689-1
Socket (18-24 gauge)
(1) 350550-1
Socket (14-20 gauge)
(2) 640310-1
Socket (10-12 gauge)
(14) 350547-1
Pin (14-20 gauge)
