4
INSTALLATION
C. Connecting The Wires
STEP 1
Awning Wires
Mounting
Enclosure Wires
• Connect the black wire to the black wire and red wire to
the red wire by stripping and crimping the wire splices .
CLICK!
STEP 2
Mounting
Enclosure
Hardware
Arm
•
Coil excess wire inside enclosure and then close the lid and
firmly snap in place.
• Cut wire cover removed in Section B to length and reinstall .
OPERATION
PROJECTILE HAZARD . Do
NOT
leave the power wand attached to the awning while the vehicle is in motion . The unit
can become a projectile if left attached during transit. Failure to obey this warning could result in death or serious injury.
A. Operating The Power Wand
STEP 1
Power
Wand
Mounting
Enclosure
Connector
Power Wand
Connector
Mud Plug
STEP 2
Power Wand
Awning
•
To disconnect the Power Wand reverse the instructions in STEP 1, reinstall the mud plug, and store for next use.
