3
INSTALLATION
These instructions assume an awning is already installed . The awning pictured may vary from the actual awning installed but the
installation procedure remains the same .
A. Installing The Battery
STEP 1
Battery
Power Wand
Snaps
B. Mounting The Connection Enclosure
STEP 1
Power Wand
Hardware
Arm
Connector
The awning may have to be opened slightly to allow room
to mount the connection enclosure .
•
TEMPORARILY
connect the Power Wand to the hardware
arm wiring by carefully pushing the black and red wires of
the hardware arm harness into the two-place connector on
the Power Wand .
• Open the awning by operating the switch on the Power
Wand .
• Remove the temporary connection before proceeding with
the installation .
STEP 2
Wire Cover
Hardware
Arm
STEP 3
Mounting
Screws or
Pop Rivets
STEP 4
Mounting
Screws
Hardware
Arm
Mounting
Enclosure
• Re-install the screws or pop rivets that were removed in
STEP 3.
STEP 5
Mud Plug
Wire
Connection
Mounting
Enclosure
• Place the mud plug over the red and black connection
wires from the hardware arm .
