6
SaniGard™ Holding Tank Vent Filter*
With odor-removing filter media, the vent filter stops odors from
escaping the holding tank vent. Keeps boats smelling clean
and pleasant. Each
cartridge is good for
an entire season and
is easily replaced.
Plumbing Connection Dimensions
Inlet Fitting Size:
1-1/2 inch
38.1 mm
Outlet Fitting Size:
1-1/2 inch
38.1 mm
Vent Inlet/Outlet Size: 5/8 inch
15.9 mm
Electrical Requirements
12 VDC
24 VDC
Vacuum Generator:
10 amp
5 amp
Level Indicator:
3 amp
3 amp
Discharge Pump:
10 amp
5 amp
†
†
† Requires separate circuit breaker.
HTS COMPONENTS
VacuFlush
®
Vacuum Generators*
On HTS-VG models, VacuFlush vacuum generators combine
the vacuum tank and vacuum pump in one unit. All models
eliminate hose runs between the vacuum tank and pump that are
found in previous VacuFlush systems. HTS vacuum generators
feature Q-series vacuum pumps, offering quieter performance
and faster vacuum generation than previous models.
OTHER HTS FEATuRES
OdorSafe
®
Plus Sanitation Hose
OdorSafe Plus hose provides the best odor barrier of any
marine hose available.
It delivers up to 19 times
greater resistance to
sulfurous malodors
than other “no-odor”
marine hoses. On HTS
models, it's used for all
1 1/2-inch (38mm) hose
connections. It's also
best for connecting the
discharge pump to the
through-hull and deck
waste fittings.
Diptube Discharge
Our diptube discharge design allows for
removal of waste from the top of the hold-
ing tank rather than near the bottom of
the tank. This feature greatly reduces the
opportunities for stagnant sewage to sit in
tank discharge lines – a main cause of odor
permeation and hose failure.
PLuMBING, ELECTRICAL SPECIFICATIONS
Dometic, OdorSafe, SeaLand, TankWatch and VacuFlush are registered trade
-
marks of Dometic Corporation.
SaniGard, SaniPump and TankSaver are trademarks of Dometic Corporation.
TankSaver™ Vacuum Relief Valve
Prevents damage due to tank implosion from
dockside pumps that generate very high
vacuum. TankSaver valve opens automatically
under vacuum, but remains sealed regardless
of shock-loading or vibrations.
TankWatch
®
4 Level Monitor and Micro-Float
Switches*
Includes four tank
levels – Empty, Low, Mid
and Full. Micro-float
switches are installed in
holding tank. No electri-
cal components contact
waste or water. Operates
on 12 or 24-volt DC.
Uses only .017 amps
at 13-volts. Micro-float
switches are installed
either as a unit (with a
TankWatch cap) or as
separate indicators.
SaniPump™ Overboard
Discharge Pump*
Runs dry without harm. Draws
6 amps at 12 VDC. Delivers
flow rate of 3.9 gallons per
minute (14.7 liters per minute).
Connects to through-hull fitting.
Check Marine Sanitation Regu-
lations for information on areas
where discharge is allowed.
* Not available on all HTS models.
VacuFlush Shut-
down Relay*
To prevent overfilling a
holding tank, a shutdown
relay is supplied with
HTS-VG models. When
the tank reaches "Full",
the relay shuts off the
vacuum generator, preventing further flushing of the toilet.
Separate
Float Switches
Combined
Float Switches
