Page 9
Siren Advanced User Manual
Physical Installation
The device should already be included in your Z-Wave system before continuing
further. Study the Pre-Installation Checklist below for a broad overview of in-
stallation options and other notes to bear in mind .
Pre-Installation Checklist
9
The Siren can be mounted on a wall or placed on shelf or tabletop
9
The Siren is loud enough to be audible from inside a drawer
9
The BACK COVER twists CLOCKWISE to be removed
9
The Siren should be included in your Z-Wave System prior to installation
9
Confirm that your device can communicate with your Z-Wave Controller
from the final installed location before proceeding
Installation—With Double-Stick Tape
1. Wipe the surface you wish to attach the Siren to clean of any residue.
2. With the Siren completely assembled, peel the preapplied adhesive backing
and firmly push it against the wall.
Installation—Using Keyhole Slot
1. Drive a screw into the surface the Siren will be attached to, leaving it 1/8”
away from being completely flush.
2. Slide the fully assembled Siren around the screw, into the keyhole slot, and
pull it down to completely secure the device around the screw.
Installation—With Screws
1. Remove the BACK COVER by twisting it clockwise.
2. Hold the BACK COVER on the surface it will be attached to, and drive two of
the included screws through indentations on the BACK COVER. You may option-
ally install anchors in the wall for added support.
3. Twist the MAIN BODY counter clockwise onto the BACK COVER.
Physical Installation
