IMPORTANT
When use AC power supply, it must be connected with the Red wire(AC1)
and the Pink wire (AC2) of the reader. It is forbidden to connect the AC
power to Black wire (GND), or the reader will be damaged. Install a
1N4004 or equivalent diode is needed when use a common power
supply, or the reader might be damaged. (1N4004 is included in the
packing).
SET CARD READING TYPE
NOTE:
• If no Master Cards added, must press the Exit Button for at
least 10 seconds before release
• Reset to Factory default, the user's information is still retained.
TO RESET TO FACTORY DEFAULT: Power off, press the Exit
Button, hold it and power on, there will be two beeps, and the
LED light turns into orange, release the exit button, then read any
two 125KHz EM card or HID card, the LED will turn into red,
means reset to Factory default successfully. Of the two cards
reading, the 1st one is Master Add Card, the 2nd one is the
Master Delete Card.
Master Code
*
*
Programming Step Keystroke Combination
Enter Programming Mode
Read EM & HID® card
OR
Read EM card only
OR
Read HID® card only
#
9 3 #
Exit
(factory default)
9 4 #
9 5 #
MASTER CARD USAGE
Using Master Card to add and delete card users
Add a Card User
Delete a Card User
1. (Read Master Add Card)
2. (Read User Card)
Repeat Step 2 for additional user cards
3. (Read Master Add Card)
1. (Read Master Delete Card)
2. (Read User Card)
Repeat Step 2 for additional user cards
3. (Read Master Delete Card)
