1
Check if the water tank contains enough fresh drinking
water. Switch on machine. Power button starts blinking red
while machine is heating up for approximately 40 seconds.
Afterwards power button lights steady green. Machine is
ready to be used.
2
To adjust drip tray position: Turn drip tray counter
clockwise to unlock it. Lift it to the desired position and
lock it by turning it clockwise until it clicks. The drip tray is
locked.
3
Place cup with correct cup size on drip tray. See
"BEVERAGE EXAMPLES" or package. Open locking handle.
Pull out capsule holder. Make sure rinsing tool is not
inside. Insert first capsule in capsule holder. Insert it back
into machine. Close locking handle.
4
Push selection lever to the "HOT" or "COLD" position as
recommended on capsule packs. Beverage preparation
starts.
STOP
5
Stay beside the machine throughout the preparation!After
reaching the desired level push selection lever to the
“STOP” position. Machine stops preparation.
6
After finishing preparation the power button blinks red for
about 5 seconds.
During that time do not open locking
handle!
7
Open locking handle. Pull out capsule holder. Remove used
capsule. Put used capsule in dustbin.
8
Insert second capsule in capsule holder. Insert it back into
machine. Close locking handle.
9
Push selection lever to the "HOT" or "COLD" position as
recommended on capsule packs. Beverage preparation
starts.
11
6.
PREPARING A BEVERAGE
6. 2 TWO CAPSULES (E. G. CAPPUCCINO)
