5
and monitor easier. The color backup camera system is a supplement to
standard rear-view mirror systems, and will provide additional rear-view
vision when installed and maintained properly. It is not intended in any
way to be a substitute for careful and cautious driving.
GETTING STARTED
TEST THE SYSTEM
We recommend doing a benchmark test before installation to insure that all
components are working properly.To ensure the system works properly
after installation, all components should be tested and checked before
installation.
Firstly
, refer to the what’s in the box page to check whether the component
is missing. We do not rule out that some components may be damaged in
the case of violent loading and unloading during transportation.
If so, please contact us in time.
Secondly
, connect the power cable(9 pin connector) to the monitor, the
positive and negative terminals to 12-32v voltage, then the power indicator
will turn blue and all the buttons into blue backlight, indicating the
successful test of the display, can work normally.
Finally
, connect 4-pin connector(the other end of the power cable)to the
backup camera, restart the power supply of the monitor, and the
corresponding channel image will appear, If display normally, so the
backup camera is working properly. If not please refer to the
troubleshooting.
Note
: The monitor can only display the image of the camera of the
corresponding channel, if your camera is connected to the AV1 channel,
please switch the monitor to AV1.
BEFORE BEGINNING INSTALLATION
As the camera needs to be fixed on the vehicle, it may need to drill a
hole on your car, before drilling please measure the size of boreholes and
check that no cable or wiring is on the other side of the wall.
Keep all cables away from hot or moving parts and electrical noisy
components.
Please clamp all wires securely to reduce the possibility of them being
damaged while vehicle is in use.
INSTALLATION GUIDE
SYSTEM CONNECTION DIAGRAM
