16
Note:
The sound and vibration indication can be set to a maximum of 4 dogs vizual
indication is adjustable for 9 dogs. When setting sound and vibration indication,
individual dogs can be recognized by the number of beeps/vibrations (maximum
4 beeps or vibrations), which indicate movement/stillness of the dog. If the
sound and vibration indication are set for more dogs, vibration and sound run
simultaneously.
For a clearer distinction between the state of motion/stillness the sensitivity of the
motion detection can be set.
1.
Press again and hold the button
BEEPER
. Letter (Sensitivity) lights up on the
display and the sensitivity level
.
2.
Adjust the sensitivity level by arrows / . Higher number means higher sensitivity,
ie. the device responds to the smaller movements of the dog.
3.
Press to return to the main screen.
indication
mode number
movement
stillness
0
lettering BEEPER flashes
-
1
-
audible
2
audible
-
3
-
vibratory
4
vibratory
-
2.
By arrows choose the number of the required dog on the receiver main panel.
3.
When switched on
, move targets of the transmitters and receiver close together
(same as when switching ON) and hold them together for 3 seconds - until you hear
a rising tone.
4.
Move the receiver away from the transmitter.
If you have activated the function correctly, the receiver display shows lettering
BEEPER
in the main navigation panel. The top line of the display shows lettering
BEEPER
if this
function is activated on the transmitter of at least one of the dogs.
Sensitivity and BEEPER mode setting
BEEPER distinguishes the movement of the dog or his immobility (drawn game) and
allows three kinds of indication - visual on the display, audible or vibration.
1.
In the main navigation panel choose a number of the requiered dog.
2.
Press and hold the button
BEEPER
on the receiver - on the display appears lettering
(M-mode and mode number 0-4).
3.
Choose requiered mode according to a table below by arrows / :
Summary of Contents for DOG GPS X20
Page 1: ...EN User guide ...
