Dogtra ARC HANDSFREE, Owner'S Manual

Page: 8 / 19

13 12
Nick
Pager
HANDSFREE
Remote
Controller
Button
Constant
2. Loop the strap back through the top section of the buckle.
Changing the HANDSFREE Remote Controller
Stimulation Mode
The default setting for the HANDSFREE Remote Controller
Strap is the Constant stimulation.
To change the setting to the Pager or Nick stimulation (or
back to Constant stimulation) proceed with the following
steps:
1. Begin with the transmitter turned off.
2. On the handheld transmitter, hold down the following
buttons to code the desired function on the HANDSFREE
Remote Controller.
Constant = Hold down the on/off button only and the
Constant
Pager
= Hold down the on/off button and the Pager
Nick = Hold down the on/off button and the Nick
Hold down these buttons until you see a rapid blinking
light on the transmitter.
3. Once you see the rapidly blinking light, release the
buttons.
4. Hold down the HANDSFREE Remote Controller button
until the rapidly flashing light on the transmitter and
controller both show a solid light.
5. Release all buttons. The HANDSFREE Remote Controller
should now be coded.
Battery Life
The LED on the HANDSFREE Remote Controller will blink
when the button is pressed. Replace the battery in the
HANDSFREE Remote Controller when the LED no longer
blinks. With normal usage (button held for 12 seconds, 100
times a day), the battery should last 7-10 years.
Fastening the HANDSFREE Remote Controller Strap
The HANDSFREE Remote Controller strap can be fastened
to your fingers, wrist, palm, or around a gun stock. Follow
the fastening instructions below.
1. Wrap the strap around the object you are fastening the
strap to. Pull the strap through the lower section of
the buckle and use the notch to keep the HANDSFREE
Remote Controller securely in place.