21
20
Battery Charging Procedure
The ARC HANDSFREE uses lithium-polymer batteries.
The battery charger and charging cables allow you to
charge both the transmitter and receiver at the same time.
The battery charger is designed for a 120 volt wall outlet.
Note 1:
Only use Dogtra-approved lithium polymer batteries
and chargers for your Dogtra e-collar. This will prevent any
damage that can be incurred from attempting to use a
different charger.
Note 2:
The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the e-collar, be sure to give
it a full 2-hour initial charge before the first use. When a
charger is not in use, disconnect it from the power source.
1. Attach the charging cables to both the transmitter and
receiver, as shown above.
2. Plug the charger into a 120 volt wall outlet or, if using the
auto charger, plug into a cigarette lighter only for lithium
polymer batteries (use a 230 volt European charger
for Europe). All indicator lights should glow red when
properly plugged in and the unit will automatically shut
off during the charging process. You will need to turn the
unit on again before use once the unit is fully charged
and unplugged from the battery cable.
3. The lithium polymer battery is fully charged within 2
hours. The lights will stay red during the charging
process. The red light will turn green once the unit is fully
charged.
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver.
Summary of Contents for ARC HANDSFREE
Page 1: ......
