MESSAGE
DESCRIPTION
Press Brake Pedal Delayed Startup
This messages appears when the key is
first turned ON, if the brake is fault
and/or the shift lever is not in NEUTRAL
(N). The shift lever must be in the NEU-
TRAL (N) position, and the brake pedal
must be pressed, to allow engine crank-
ing. Place the shift lever in NEUTRAL (N)
and apply the brake pedal BEFORE turn-
ing the key to the START/AVV position;
otherwise, the engine will not crank and
the key must be cycled OFF, then back
on, before cranking is allowed.
Gear Not Available
This message appears, along with a warn-
ing buzzer:
•
When it is not possible to change gear
due to a fault in the system.
•
When, due a fault in the system, it is
only possible to engage 1st (1), 2nd
(2), 3rd (3) or reverse (R).
Contact your authorized dealer if the mes-
sage continues to appear.
Shift Not Allowed
This message appears, together with a
warning buzzer, when the system will not
allow a gear change requested by the
driver (for example, that would cause en-
gine overspeed or transmission damage).
This message may also appear when
starting the engine at low temperature. In
this case the Automated Manual trans-
mission isn't able to engage first gear, in
this situation either use the engine block
heater or allow the engine to idle in NEU-
TRAL (N) until the transmission has
warmed.
Press Brake Pedal And Try Again
This message appears accompanied, in
some cases, by a warning buzzer, if you
attempt to change gear with the vehicle
parked without pressing the brake pedal.
To shift the transmission (with key on/
engine off), press and hold the brake
pedal, move the shift lever to NEUTRAL
(N), then move the shift lever to the de-
sired position.
DIESEL
51
