Dodge 1997 Neon WIRING DIAGRAMS, Owner'S Manual

Page: 5 / 256

CIRCUIT IDENTIFICATION
All circuits in the diagrams use an alpha/numeric
code to identify the wire and its function (Fig. 3). To
identify which circuit code applies to a system, refer
to the Circuit Identification Code Chart. This chart
shows the main circuits only and does not show the
secondary codes that may apply to some models.
CONNECTORS
Connectors shown in the diagrams are identified
using the international standard arrows for male and
female terminals (Fig. 4). A connector identifier is
placed next to the arrows to indicate the connector
number (Fig. 4).
For viewing connector pin outs, with two terminals
or greater, refer to section 8W-80. This section iden-
tifies in-line connectors by number, and component
connectors by name. If a component has two or more
connectors they will be identified as C1, C2, C3...etc.
This sections also provides terminal numbering, cir-
cuit identification, wire colors, and functions.
All connectors are viewed from the terminal end
unless otherwise specified. To find the connector loca-
tion in the vehicle refer to section 8W-90. This sec-
tion uses the connector identification number from
the wiring diagrams to provide a figure number ref-
erence.
TAKE OUTS
The abbreviation T/O is used in the component
location section to indicate a point in which the wir-
ing harness branches out to a component.
SYMBOLS
Various symbols are used throughout the Wiring
Diagrams. These symbols can be identified by refer-
ring to the symbol identification chart (Fig. 5).
Fig. 3 Circuit Identification
Fig. 4 Connector Identification
PL
8W - 01 GENERAL INFORMATION 8W - 01 - 3
DESCRIPTION AND OPERATION (Continued)