S
ETUP
**CAUTION: DO NOT TURN ON THE POWER AMPLIFIERS YET.
Consult your speaker and driver manufacturer's specifications for the
recommended crossover frequencies. Basic setup procedures for the
crossovers are as follows:
• Label each power amplifier for its respective frequency band.
SR834: LOW, MID, or HIGH for stereo operation; LOW, LOW-MID, HIGH-MID,
or HIGH for mono operation.
SR823: LOW, HIGH for stereo operation or LOW, MID, HIGH for mono
operation.
• Set each power amplifier volume control at maximum and connect each
power amplifier output to its correct speaker or driver.
• Apply power to the crossover. Apply power to the mixer then the power
amps.
STEREO OPERATION
Using the markings non-italicized markings on the front and rear panels and set
each channel as follows:
• Set the gain control to 0 dB. Set all level controls to -12 and switch in the
15Hz high-pass filter if desired.
SR823: Set the LOW/HIGH crossover frequency for each channel according to
the front panel markings. If below 180Hz is desired, press the ÷10
switch** on the rear panel.
SR834: Set the LOW/MID crossover frequency for each channel according to
the front panel markings. If below 180Hz is desired, press the ÷10
switch** on the rear panel. If the desired frequency is below 180 Hz,
the ÷10 switch must be engaged (LED indicator lit). If the desired
frequency is above 180 Hz, the Range switch must be disengaged
(LED indicator off).
When the ÷10 switch is engaged, the frequencies marked around the LOW/MID
(LOW/HIGH for SR823) frequency control are divided by 10. In other words, if
the LOW/MID (LOW/HIGH for SR823) frequency is set at 250Hz and the range
switch is engaged, the actual crossover frequency is 25Hz.
SR834: Set the MID/HIGH crossover frequency. The Channel 2 MID/HIGH
frequency control has two sets of markings. When using the
crossover in stereo mode, use the lower frequency markings to set the
MID/HIGH crossover point. This frequency control has no range
switch.
WARNING: BEFORE PRESSING THE ÷10, LF SUM OR STEREO/MONO
SWITCHES, LOWER THE OUTPUTS OF YOUR POWER
AMPLIFIERS TO AVOID DAMAGE TO DRIVERS AND
LOUDSPEAKERS.
SR Crossover
3
