DECLARATION OF CONFORMITY
Manufacturer’s Name: DOD Electronics Corporation
Manufacturer’s Address:
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
declares that the product
Product Name:
BASSTEC
Product Options: All conforms to the following product
specifications:
Safety:
EN 60065 (1993)
IEC63 (1985) with Amendments
1,2,3
EMC:
EN 55013: (1990)
EN 55020: (1991)
Supplementary Information:
The product herewith complies with the requirements of
the Low Voltage Directive 73/23/EEC and the EMC
Directive 89/336/EEC as ammended by directive
93/68/EEC.
DOD Electronics Corporation
President of DOD
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
Effective: 8/26/97
European Contact: Your Local DOD Sales and Service Office or
International Sales Office
3 Overlook Drive #4
Amherst, New Hampshire 03031, USA
Tel (603) 672-4244
Fax (603) 672-4246
DOD Electronics
8760 South Sandy Parkway
Sandy, Utah, 84070
Telephone (801) 566-8800
FAX (801) 566-7005
International Distribution: 3 Overlook Drive, Unit 4
Amherst, New Hampshire 03031 U.S.A.
FAX (603) 672-4246
BASSTEC is a registered trademark of DOD
Electronics
Copyright © 1997
DOD Electronics
Printed in U.S.A.
BASSTEC
Accessories for the BASSTEC
Gig Bag
VCC1 Volume/Continuous Controller
Warranty
1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty.
2. DOD warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.
3. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is
returned to DOD WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one (1) year. A Return Authorization
number may be obtained from DOD by telephone. The company shall not be liable for any consequential damage as a result of the product’s use in
any circuit or assembly.
4. Proof-of-purchase is considered to be the burden of the consumer.
5. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to
install the same on products previously manufactured.
