Docomo L-03C, Instruction Manual

Page: 145 / 158

29
AT Commands Overview Parameters/Descriptions
Command
Examples
AT&C<n> Set the operating
conditions of the circuit
CD signals for DTE. n=0 : Always keep circuit CD
signal ON.
n=1 : CD changes depending
on the other party
modem carrier (default)
AT&C1
OK
AT&D<n> Set the operation
performed when a circuit
ER signal received from
DTE is switched from
ON to OFF. n=0 : Ignore ER signals
(Always regard as ON).
n=2 : When ER signals
are turned off by
disconnecting, the
PC switches over to
the offline command
mode(default)
AT&D2
OK
AT&E<n> Set interval velocity. Only n=0 can be set (Only
support wireless interval
velocity) (optional)
－
AT&F<n> Restore all registers
to their defaults. If this
command is entered
during communication,
the line will be
disconnected. Only n=0 can be set (optional) －
AT&W<n> Store the current setting
value to the FOMA
terminal. Only n=0 can be set (optional) －
AT*DANTE Display the signal
strength (number of
antenna bars) of the
FOMA terminal. Result format:
*DANTE:<m>
m=0 : Out of service area
m=1 : State of 0 or 1 antenna
bar displayed
m=2 : State of 2 antenna bars
displayed
m=3 : State of 3 antenna bars
displayed
AT*DANTE
*DANTE:3
OK
AT*DGPIR=<n> Set whether to show
or hide the caller ID to
the access point during
packet communication.
The setting of this
command is enabled
when a call is made. This
setting can also be set
by adding 184 (hide) or
186 (show) to the access
point number when
configuring the dial-up
network settings. → P20 n=0 : Connect with the APN
setting as is.
n=1 : Connect with 184 (hide)
added to the APN.
n=2 : Connect with 186
(show) added to the
APN.
AT*DGPIR?
: Display the current setting
value.
AT*DGPIR=0
OK
AT*DGPIR?
*DGPIR:0
OK
AT*DRPW Display the received
power indication value
of the FOMA terminal
(minimum value to
maximum value: 0 to 75). － AT*DRPW
*DRPW:25
OK
AT+CACM="<pas
swd>" Reset the cumulative
billing value recorded on
the UIM (FOMA card). passwd: PIN2 code
If the entered PIN2 code is
correct, the cumulative billing
value is reset. ("1234" is entered
for the PIN2 code)
AT+CACM="1234"
OK