Docking Drawer DD 21 Slim, Install Manual

Page: 4 / 5

4
Removing the Receptacle Box–
For­a­successful­Docking­Drawer­Slim­charging­outlet­installation,­it­is­ NOT ­necessary­to­remove­the­
receptacle­box­from­the­cable­management­arms.­However,­if­the­receptacle­box­needs­to­be­removed,­
please­follow­these­steps­to­disconnect/reconnect­the­receptacle­box­from­the­cable­management­arms.
1.
­Remove­the­cable­arm­ground­connection­
inside­the­receptacle­box­by­removing­the­
green­ground­screw­and­ring­terminal­as­
shown.­
DO NOT
­remove­the­ground­wire­
that­goes­to­the­receptacle.
4.
­Mount­the­power­cord­bracket­in­the­correct­
location­on­the­back­wall­behind­the­drawer­
as­shown­in­the­drawing.
5.
­Install­the­drawer­in­the­cabinet,­and­hold­on­
to­the­end­of­the­arm­assembly.­
6. ­Pass­the­wires­from­the­cable­management­
arms­into­the­receptacle­box­and­reattach­
the­bracket­using­the­screwdriver­and­
(2)­#10­screws.­
7. ­Secure­the­receptacle­box­to­the­back­of­the­
drawer­using­the­installer­supplied­hardware.
8.
­Reconnect­the­black­wire­from­the­circuit­
breaker­to­the­black­wire­from­the­cable­
management­arm­using­the­blue­wire­nut.
9. DO NOT FORGET TO REATTACH THE
GROUND WIRE INSIDE THE RECEPTACLE
BOX. TORQUE SCREW TO 16-18 IN-LBS.
ENSURE THAT THE CIRCUIT BREAKER IS
WIRED IN SERIES WITH THE LINE (BLACK)
WIRE. SEE WIRE DIAGRAM.
2. ­Remove­the­blue­wire­nut­connecting­the­
black­wire­from­the­cable­chain­to­the­black­
wire­going­to­the­circuit­breaker.
3.
­Use­a­Phillips­head­screwdriver­to­remove­the­
(2)­#10­screws­from­inside­the­receptacle­box.­
This­will­allow­the­cable­arm­bracket­to­be­
disconnected­from­the­receptacle­box.­
MAKE SURE BOTH GROUND SCREWS
ARE SECURELY CONNECTED!
TORQUE TO 16-18 IN-LBS
DO NOT REMOVE