doble TDR9000, User Manual, Page: 156 / 454

Configuring Test Plans
4-58 72A-1898 Rev. A 11/01
Monday
, November 26, 2001 1:09 pm
Clicking these buttons:
Displays the first window of the testing sequence.
Refer to ”Running Tests” on page 4-75.
Displays a window, comprised of three tabs, where
the command parameters, including the triggers,
for that test type are configured or reconfigured
from an original Library Test Plan or Breaker Test
Plan. A complete description of command
parameters is given in
”TDR9000 ™ TRXField™
Software and Test Plan Dynamics” on page A-28.
These three tabs include:
• XXX Parameters ( XXX is the test being run) –
Refer to ”Parameters Tab”.
• Trigger Input – Refer to page 4-64.
• Trigger Output – Refer to page 4-66.
The Trip Parameters window (Figure 4.37) is used to explain
functionality. The Trigger Input and Trigger Output windows are the same
regardless of test type. Additional parameters for the Close test are listed
in Table 4.4 on page 4-61. Table 4.5 on page 4-62 lists the general
command parameters from the
XXX Parameters tab that are available by
test type.
Configuring the
Command
Parameters Configuring the command parameters for a test depends on the test type.
The Command Parameters window can be accessed in one of two ways:
• Click the XXX Parameters button.
or
• Click either the Trigger In or Trigger Out System module Virtual
Front Panel connectors, as shown in Figure 4.35.
Figure 4.35 Virtual Front Panel Trigger Connectors