Dobinsons Springs and Suspension
Fitting Guide
1.
Remove the number plate and remove the
grill.
2.
Remove the clips along the top of the
bumper, the bolts along the edge of the wheel
arch and lower section of the bumper
attaching the bumper to the vehicle.
3.
Carefully unclip the bumper from the edges
and under the headlights and carefully
remove.
4.
With the bumper off you can now remove the
steel bumper mount and steel crush cans.
If removing the original bullbar some models
require the bullbar to be removed first, then
there are also bolts in the centre of the bullbar
mounting crush cans that need to be removed
as well before removing the original crush
cans.
5.
From inside the chassis rails loosely install the
U-bolts supplied (item 3) facing out as seen on
page 3.
6.
Loosely install the small mounting brackets
(item 2) to the outside of the chassis as per
diagram on page 3.
7.
Install the bullbar mounting bracket (item 1).
Washers can be placed between the top and
bottom bolts between items 1 and 2 to take
up the gap as per the picture below. Ensure
though that when tightening the bracket
tights correctly and the washers do not sit
behind between the chassis and mounts.
