SE-0119 WIRELESS DOOR ALARM W/REMOTE
Magnetically Triggered Door Alarm and Remote Control
PACKAGE INCLUDES:
y
Main Unit ... 1PC
y
Magnetic Sensor ... 1PC
y
Remote Control ... 1PC
INSTALLATION:
y
Simply peel and stick the alarm to the door or any other place you wish to protect.
y
For best performance, keep the distance between the Main Unit and Magnetic Sensor
no wider than half an inch.
y
The Magnetic Sensor can be installed on either side of the Main Unit. (see drawing
below)
BATTERY INSTALLATION/ REPLACEMENT:
Main Unit:
y
Set the switch to OFF and slide down the battery cover.
y
Follow the polarity instructions to insert 3 AAA Alkaline batteries (not included).
y
Put the battery cover back on.
Remote Control:
y
Unscrew the back cover to insert or replace 1 fresh CR2032 battery. Follow the
polarity instructions.
y
Press any button on the remote Control. The red LED will light if the battery is installed
correctly.
OPERATION:
Remote Mode:
y
Make sure the Magnetic Sensors are aligned and batteries are installed correctly.
y
After installing the batteries, slide the switch to , and the red LED will flash once.
y
Slide down the battery cover and press the small button above the battery
compartment once. A beep will sound, and the red LED will flash for 5 seconds.
y
While the LED is still flashing
, press any button on the Remote Control and you’ll
hear 2 Beeps. This indicates the code has been learned successfully.
y
After the code has been learned, wait 5 seconds, then
press and hold
the ON button
on the Remote Control. A Beep will sound, and the Main Unit will be armed within
three seconds. The red LED will flash three times indicating is has been armed.
y
Press the OFF button on the Remote Control, a Beep will sound, accompanied by a
flashing red LED. The device is now disarmed.
y
Under ARM status, once the door is opened, the alarm will go off continuously for 30
seconds.
y
Turn off the alarm by pressing the OFF button on the Remote Control or slide the
switch to OFF on the Main Unit.
Manual Mode:
y
Make sure the Magnetic Sensors are aligned and that the batteries are installed
correctly.
y
Slide the switch to , and the Main Unit will be armed in three seconds and the red
LED will flash three times.
y
Once the door is opened, the alarm will go off continuously for 30 seconds.
y
Turn off the alarm by sliding the switch to OFF.
1
