20
9.
After the cut has been completed, the saw band will
shut off with the saw head in the forward position.
Next:
(a)
Retract the saw head by moving the
Feed
selector to "reverse" (move the selector to "hold"
when the desired saw head position is reached);
(b)
Turn the
Vse
selector (and
Nesting Fixture(s)
if supplied) to "open";
(c)
Remove the cut-off piece
either by means of the hand crank for the table
rollers, or by use of controls for material handling
equipment if supplied.
DO NOT remove any cut-off peces untl they
are away from the saw band or the saw band
has stopped completely.
For future reference, keep a record of band
speed, feed rate, feed force and coolant
applcaton settngs for successful jobs.
Automatc Operaton
1.
Follow Steps 1 through 6 in the
"Manual Operation"
section.
2.
Turn the
Operaton
selector to "automatic'. Then:
(a)
Turn the
Coolant
selector to "band on" (or
"normal' on some older machines);
(b)
Turn the
Band
selector to "run";
(c)
Turn the
Band Speed
and
Band Feed
valves to initial settings;
(d)
Turn
the
Coolant
valve on and adjust so that the saw
band is shrouded with coolant.
8.
Turn the
Feed
selector to "forward" and then the
Head
Approach
selector to "normal". Next:
(a)
Push the
Cycle Start
button;
(b)
Watch closely as the saw
head moves forward and make any adjustments
to band speed, band feed, coolant volume, head
approach and/or feed rate settings as needed.
9.
After the cut has been completed, the saw band
will stop running and the saw head will retract until
it trips the head reverse limit switch, then stops.
10.
Next:
(a)
Turn the
Vse
selector (and
Nestng
Fixture(s)
if supplied) to "open";
(b)
Remove the
cut-off piece either by means of the hand crank for
the table rollers, or by use of the material handling
equipment controls if supplied;
(c)
If another cut
is to be made, move the stock into desired cutting
position, clamp the vise and then push the
Cycle
Start
button.
DO NOT remove any cut-off peces untl they
are away from the saw band or the saw band
has stopped completely.
TYPICAL OPERATING PROCEDURES
(Continued....)
For future reference, keep a record of band
speed, feed rate, feed force and coolant
applcaton settngs for successful jobs.
Summary of Contents for TF-2525
