6
Power On LED
The power on (green) LED turns on when unit is powered up and stays on as long as unit is in normal
operating condition. If the green power on LED is not on after you power on the main switch. The
unit has a problem and is not in proper operating condition. If the green power on indicator will not
illuminate, the unit has an operational problem and needs to be checked out by your dealer or
authorized DNA service center.
Peak Level LED
The amber colored Peak Level LED flashes briefly when your unit
’s
output amplifier exceeds 0.01%
total harmonic distortion. This function is basically a peak output indicator, though it comes on at well
below the actual peak output of the amplifier.
Input Pad
Located on the Gain control pot. Use this control switch to reduce the signal level of your bass if it is
coming into your unit at too high a level to match up correctly with the input gain control.
DI Level Send
Located on the back panel. DI Level Send allows you to control the level of the DI signal going to
the
mixing or recording console. This control allows you to adjust from microphone level to low line level.
DI Pre/Post Switch
Located on the Shape control pot. The Pre/Post DI switch allows you to select either pre-tone or post
tone single configuration to send to the DI output. This feature is only available from the front panel.
Compressor Threshold Control
The Threshold Control sets the level at which the compressor begins to compress. This is also called
the knee of the compressor. Turning the control to the right will allow the compressor to engage
sooner. Turning the control more to the left it will let the compressor engage at a higher signal level
or not at all.
Compressor Ratio Control
The Compressor Ratio Control allows you to select the way the signal is compressed. When the
control is set to the left side near zero, it will compress very gently, at a low compression ratio. As the
control is turned to the right, the ratio will become higher until it becomes a hard limiter at the control
’s
far right position.
Compressor Bypass Switch
Located on the Threshold control pot. The Compressor Bypass Switch allows you to preset the
compressor to the desired level or effect in playing situations, and then to bypass the compressor,
when you no longer want to use the compression effect. Note: The comp. Led will not blink while
playing when it is in the bypass mode.
