3
Connect your DNA Series bass guitar amplifier and appropriate speaker of a similar power rating,
using the NL-4 connectors on the rear of the amplifier chassis. The NL-4 connectors on both your
amplifier and your DNA speaker cabinet are wired together in parallel (see below)
Connect your
amplifier using one connector and use the other one to connect another speaker cabinet if desired.
Make certain that the total impedance of all speaker cabinets you are using is no lower than the
minimum rated impedance (4
Ω) of your amplifier.
Always make all speaker connections before
turning your amplifier on.
.
Connection Notes!
NEVER
connect two different amplifiers together, or two channels of the same amplifier, into one
cabinet. This will be very likely to seriously damage your amplifier and possibly the speaker cabinet
as well.
IMPROTANT NOTE:
DO NOT
use a light gauge
shielded instrument type cable
to connect your
amplifier and speaker together. This will cause very poor performance and may even cause the
amplifier to oscillate and distort. Always use a good quality, heavy gauge speaker cable 16 gauge
min. or preferably 12 - 14 gauge cables for the best results.
Output connections
:
We use NL-4 type connectors. NL-2 type and NL-4 type cables are both
acceptable. Note that the +1/+2 pins are connected together as are -1/-2 on both the NL4 connectors
in your cabinet. This is to allow you to get the lowest impedance possible in your cable connection for
best bass response and peak power delivery. We also provide a
¼” connector for
temporary short
term emergency use
only. The ¼
”onnector should not be used in place of the NL4 connections for
