![background image](http://html1.mh-extra.com/html/dmx4all/dmx-led-dimmer-x9-hr/dmx-led-dimmer-x9-hr_user-manual_2514385009.webp)
DMX-LED-Dimmer X9 HR
9
Configurating the LookUp-Table
The
DMX-LED-Dimmer X9 HR
has one LookUp table per output. The received DMX-
channel has values from 0 up to 255. However the DMX-LED-Dimmer X9 HR output
driver provides 65536 steps (16 Bit) which will be assigned to the DMX-values.
So it‘s possible to effect with small steps little brightness changings in the lower
brightness range. However in the upper brightness range it’s possible to program
bigger steps.
To define the LooUp table please use the program DMX-LED-Dimmer PC-
Control from V2.1. For every output exists a table with the DMX-values from 0-
255 and the corresponding output valus. A graphically presentation of the table
represents the output charateristics:
For transferring the table into the
DMX-LED-Dimmer X9
HR
a PC-connection cable and a USB-connection from the
PC is necessary. Please connect the cable and the PC one
another and the CTRL-connection from the
DMX-LED-
Dimmer X9 HR
as shown in the right picture.
Now, start the software DMX-LED-Dimmer PC-Control.
Select
Write
to transfer the table from the displayed output.
Software-Reset
A RESET for the LookUp table of the
DMX-LED-Dimmer X9 HR
will be executed by
adjusting switch 1 until 10 on ON and than turning on the supply voltage. During the
reset the LED flashes with the event code 4. This will take some time so wait until the
event code 4 is not displayed.