9 A
That means you have stored the operation successfully.
Note: After finishing the current programming operation, you can hold RELEASE/CLEAR button to
clear all the output before next step operation.
4-3.2 Delete a Chase
1. Press PROGRAM/REC button to enter program mode.
2. Hold DEL button, then tap the CHASE button which you want to delete; all related LED indicators will
flash three times briefly indicating this chase has been deleted.
Note: After finishing the current programming operation, you can hold RELEASE/CLEAR button to
clear all the output before next step operation.
4-4 Assign/Reverse DMX channel
4-4.1 Assign DMX channel
1. Press PROGRAM/REC button to enter program mode.
2. Press button1-16 to select the fixture.
3. Press the FINE and MODE buttons at a time, the Assign LED lights up indicating Assign mode is active.
4. Use Up and Down button to change between the PAN and TILT, the corresponding LED lights indicating
this selection.
10 A
5. Tap the PAGE Select button to select Page A or Page B or Page C or Page D.
6. Holding the MODE button, tap the Scene button1-8, all LED should flash briefly indicating the DMX
channel is assigned.( Scene button 1 stands for DMX channel 1, Scene button 2 stands for DMX
channel 2, and so on.)
7. Continue steps 2-6, you may assign 16 fixtures for the PAN/ TILT movements. Under ASSIGN MODE,
PAN / TILT can be set both in page A and page B and page C and page D.
Note: After finishing the current programming operation, you can hold RELEASE/CLEAR button to clear all
the output before next operation.
4-4.2 Reverse DMX channel
1. Press PROGRAM/REC button to enter program mode.
2. Press button1-16 to select the fixture.
3. Press the FINE and MODE buttons at a time for two times till to the REVERSE LED lights up indicating
reverse mode is active.
4. Use Up and Down button to change between the PAN and TILT, the corresponding LED lights indicating
this selection.
5. Tap the PAGE Select button to select Page A or Page B or Page C or page D.
6. Holding the MODE button, tap the Scene button1-8, all LED should flash briefly indicating the DMX
channel is reversed.( Scene button 1 stands for DMX channel 1, Scene button 2 stands for DMX
channel 2, and so on.)
7. Continue steps 2-6, you may assign 16 fixtures for the PAN/ TILT movements. Under ASSIGN MODE,
PAN / TILT can be set both in page A and page B and page C and page D.
Note: After finishing the current programming operation, you can hold RELEASE/CLEAR button to
clear all the output before next step operation.
Summary of Contents for CA-3216W
Page 2: ...1 A 18 A ...
