15
First check if your projector is listed in the Existing projector list, if so please select the desired projector
and click the icon “programming”. Now the setup program will transmit the right RS232 code to the Host.
If your projector is not in the list, you have to setup the control protocol yourself, using the projectors
information.
Presenter control will support Projectors which are controlled by either serial port or IR-remote control.
Please refer to your projectors operating manual or consult your dealer for the right control code.
Serial port Control
First select “USER-DEFINED PROJECTOR”. Now the window shown in figure 20 will appear.
Fig. 20
Click “serial Port Control” after confirmation. Now the communication parameters will be identified in
advance.
Baudrate
Data number of bits: 7 bits or 8 bits.
Stop Bit: 1 bit.
Verification Mode: none, even, odd, space, mark.
Please look up the projectors parameters carefully in the projectors manual. If you’re not sure contact
your dealer.
Requirements for the RS232 code.
Use hexadecimal digits only. Please transform other codes to the Hexadecimal format.
The symbol “\” is necessary for separating the Hex-digits.
Special characters have to be transferred into Hexadecimal digits also. Use a ascII table for
special characters. E.g. Blank-space is “20”, the line feed character is “0A” and enter character is
“0D”.
