Chapter 1 5
Important
Do not remove batteries while the unit is powered as
this may affect the Data logger
(See Appendix:
“Additional information, Error Messages”)
The QSV has two type Lemo “00” connectors located on top of the
unit. Because this is the standard for most dual crystal probes, you
could basically connect any probe to your QSV. Keep in mind that the
gain may need to be adjusted when changing probes.
To connect the probe, simply align any
of the male connectors located at the
end of the transducer cable to any of
the female connectors located on the
gauge and press gently until
connected.
To release the probe hold the knurled
section on the male connectors and
pull gently away from gauge until
released.
Figure 1.5: Connecting the transducer
Summary of Contents for QSV-B
Page 1: ......
