V-4061DB VIDEO DOORBELL | DIGITAL MONITORING PRODUCTS
3
The video doorbell requires a 2.4 GHz Wi-Fi signal.
1. Ensure that you know the Wi-Fi SSID and password that you wish to connect the doorbell to.
2. Log into the Virtual Keypad app and go to the
Doorbell
tab.
3. Tap
Set Up Doorbell
.
4. Tap
Scan Doorbell
and scan the QR code located underneath the faceplate on the front of the
doorbell.
5. When the QR code is confirmed, press
Configure
Wi-Fi
.
6. Enter the SSID and password for the Wi-Fi network that the doorbell is connecting to and press
Continue
.
7. Use your device to connect to the doorbell’s Wi-Fi network.
For Andriod Users:
Virtual Keypad will attempt to automatically connect to the doorbell’s Wi-Fi network and configure
the Wi-Fi information for you. This may take a few seconds.
For iOS Users:
Copy the doorbell’s Wi-Fi password, then navigate to the Wi-Fi settings on your phone. The
doorbell will transmit an SSID for your phone to use. The SID will be HAP followed by the doorbell’s
serial number. For example, if the doorbell serial number is “12345678” then the SSID that the
doorbell transmits would be “HAP_12345678.” Paste the password to connect to the doorbell’s Wi-
Fi network.
Note: The password will be “AP” followed by the verification code. For example, if the verification
code is “ABCDEF”, then the password would be “APABCDEF.”
8. Navigate back to the Virtual Keypad app. Press
Continue
. When the network pairing has been
confirmed the doorbell will announce that it is connected to Wi-Fi.
9. Give the doorbell a name. You will be prompted to select the type of chime the doorbell is using.
Select
Mechanical Chime
when installing the video doorbell with a standard 16-24V mechanical
doorbell chime. Select
No Chime
when installing the video doorbell with a 16-24V plug in
transformer. If
No Chime
is selected, make sure you have installed the included fuse. The V-4061DB
is not compatible with digital chimes.
10. Press
Finish
to complete the installation. It could take up to a minute for Virtual Keypad to
finsh configuring your doorbell. When it has been successfully configured, Virtual keypad will
automatically launch into the live view.
After the doorbell has been set up in the Virtual Keypad app and after obtaining the IP address that your router has
assigned to the doorbell, follow the NVR manufacturer recommended steps to add a camera to an NVR.
1. Choose
Manual
mode to add a camera.
2. Enter the IP address.
3. Set the protocol to
Hikvision
.
4. Leave the
Management Port
at the default
8000
, the
Channel Port
as the default
1
, and the
Transfer Protocol
as
the default
Auto
.
5. The username is “admin”. The password is the verification code that is on the back of the doorbell. As an example,
if the verification code is
ILGWQM
then the password would be
ILGWQM
.
CONNECTING THE DOORBELL TO AN NVR
ADDITIONAL INFORMATION
CONNECT VIDEO DOORBELL TO WI-FI USING VIRTUAL KEYPAD APP
5
