DMP Electronics Com Series, How-To Manual

Page: 7 / 13

COM SERIES HOW-TO GUIDE: ECP PASSTHRU | DIGITAL MONITORING PRODUCTS 5
Locally (Keypad)
To advance through the programming menu, press CMD . To go back, press the Back Arrow key. To enter a
menu, press any select key or area. To select an option, press the select key or area under that option.
Before programming, ensure the ECP panel’s IP address is set as default.
1. Power up or reset the communicator.
2. At the communicator keypad, enter 6653 (PROG) and press CMD .
3. Advance to SYSTEM OPTIONS , then press any select key or area to enter the menu.
4. Advance to KYPD INPUT , then press any select key or area.
5. Select ECP by pressing the third select key or area under that option.
6. At ECP PARTN NBR , enter the number of the partition where you want the communicator to operate.
Range is 1 - 8. Default is 1 .
7. To save programming, advance to STOP and press any select key or area.
8. At the communicator keypad, enter 2313 (DIAG) and press CMD .
9. Advance to ECP SETUP and press any select key or area.
10. At ECP SETUP VISTA 128? : If the panel is a VISTA 128, select YES . Otherwise, select NO .
11. At INST CODE , enter the ECP panel installer code and press CMD .
12. After configuration is finished, the keypad advances to GET ZONES . Press any select key or area.
As the communicator retrieves zones from the ECP panel, the number of zones is displayed and incremented
as
ZONE CT (zone count).
Troubleshooting
Message Meaning Next Steps
PROGRAMMING The communicator is attempting to
configure ECP panel programming
settings for ECP Passthru. Wait for the configuration attempt to complete.
Afterward, a programming status message is
displayed (success, fail, or busy).
PROGRAM SUCCESS The ECP panel has been successfully
configured.
Finish configuration at
GET ZONES
.
PROGRAM FAIL The ECP panel could not be
programmed. Check wiring connections and communication
settings, then retry programming.
BUS IS BUSY The ECP panel could not be
programmed due to high ECP bus
traffic. Wait and retry programming or reduce traffic on the
ECP bus, then retry programming.
Table 2: Programming Messages and Troubleshooting